Installing The Canopy Housing; Assembling And Mounting The Fan Blades - Rejuvenation Heron Manual Del Propietário

Ventilador de techo

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

NOTE: This step is applicable after the necessary wiring

is completed.

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy housing

and not pinched between the housing and the ceiling.

1. Remove one of the two shoulder screws in the

hanger bracket. Loosen the second shoulder screw

without fully removing it. Assemble canopy by

rotating key slot in canopy over shoulder screw in

hanger bracket. Tighten shoulder screw. Fully

assemble and tighten second shoulder screw that

was previously removed (Figure 1a).

2. Securely attach and tighten the canopy screw

cover over the shoulder screws in the hanger

bracket utilizing the keyslot twist-lock feature

(Figure 1b).

Assembling and Mounting the Fan Blades

1. Position the blade over the blade holder with

threaded posts showing. Make sure the bottom

edge of the blade is fully seated against the

blade holder. With a Phillips screwdriver, tighten

3/16˝-24 x 11 mm washer head screws and fiber

washers to secure the blade to the blade holder

(Figure 1).

NOTE: You will find the fan blade set packed in its own

carton and the blade holders and hardware bag in the

fan box.

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled

may result in damage to the fan blades.

2. Attach blade holders to the bottom of the fan motor

hub using the ¼˝–20 x 13 mm screws w/lockwashers.

Make sure the screws with lockwashers securing

the blade holders to the fan motor hub are tight and

that the blade holders are properly seated. (Figure 2)

NOTE: Periodically check Blade Holder hardware and re-

secure if necessary. (see Maintenance below)

WARNING

To reduce the risk of personal injury, do not bend the

blade holders when installing, balancing the blades or

cleaning the fan. Do not insert foreign objects in between

the rotating blades.