Section 4 Maintenance and Troubleshooting
Maintenance
Regular maintenance will improve performance and
extend engine/equipment life. BALDR INTERNATIONAL
LLC. recommends that all maintenance work be
performed by an Independent Authorized Service Dealer
(IASD). Regular maintenance, replacement or repair of
the emissions control devices and systems may be
performed by any repair shop or person of the owner's
choosing. However, to obtain emissions control
warranty service free of charge, the work must be
performed by an IASD. See the emissions warranty.
NOTE: Call BALDR INTERNATIONAL LLC customer
service at +1 (855)801-0798 with questions about
component replacement.
Maintenance Schedule
Follow maintenance schedule intervals, whichever
occurs first according to use.
NOTE: Adverse conditions will require more frequent
service.
NOTE: All required service and adjustments should be
each season as detailed in the following chart.
At Each Use
Check engine oil level
Every 50 Hours
Clean Air Filter
Every 100 Hours or Every Season
Change Oil ǂ
Clean/Gap Spark Plug
Every 200 Hours or Every Season
Replace Air Filter
Replace Spark Plug
Check/Adjust Valve Clearance
ǂ
Change oil after first 30 hours of operation,
then every season.
1.Change oil and oil filter every month when
operating under heavy load or in high tem-
peratures.
2.Clean more often under dirty or dusty oper-
ating conditions. Replace air filter parts if
they cannot be adequately cleaned.
3.Check valve clearance and adjust if neces-
sary after first 50 hours of operation and
every 300 hours thereafter.
1
2
Preventive Maintenance
Dirt or debris can cause improper operation and
equipment damage. Clean generator daily or before
each use. Keep area around and behind muffler free
from combustible debris. Inspect all cooling air
openings on generator.
WARNING
Do not insert any object through the air cooling slots.
Generator can start at any time and could result in
death, serious injury, and unit damage.
• Use a damp cloth to wipe exterior surfaces clean.
• Use a soft bristle brush to loosen caked on dirt, oil,
etc.
• Use a vacuum to pick up loose dirt and debris.
• Low pressure air (not to exceed 25 psi)
may be used to blow away dirt. Inspect
cooling air slots and openings on generator.
These openings must be kept clean and
unobstructed.
NOTE: DO NOT use a garden hose to clean
generator. Water can enter engine fuel system
and cause problems. If water enters generator
through cooling air slots, some water will be
retained in voids and crevices of rotor and stator
winding insulation. Water and dirt buildup
on generator internal windings will decrease
insulation resistance of windings.
Engine Maintenance
WARNING
Accidental start-up. Disconnect spark plug wires when
working on unit. Failure to do so could result in death or
serious injury.
Engine Oil Recommendations
To maintain the product warranty, the engine oil
should be serviced in accordance with the
recommendations of this manual. For your
convenience, BALDR INTERNATIONAL LLC
Maintenance Kits are available that include engine
oil, oil filter, air filter, spark plug(s), a shop towel
and funnel. These kits can be obtained from an
Independent Authorized Service Dealer (IASD).
Owner's Manual for Petrol Generator