Removing The Mcs Ii System; Operation Of The Mcs Ii System - N-Com MCS II Seguridad E Instrucciones

4. REMOVING THE MCS II SYSTEM

After releasing the connector from the shell, also remove the right part by
releasing the Basic Kit2 MCS from the shell pins.
Now remove the entire Basic Kit2 MCS from the helmet.

5. OPERATION OF THE MCS II SYSTEM

Hook up the connection cable to the Harley Davidson / Honda Goldwing, then
to the MCS II system. The audio of the system installed on the motorcycle is
now transferred to the helmet.
You can use the interphone system on the Harley Davidson / Honda Goldwing
by connecting both the pilot's helmet and the passenger's to the motorcycle.
Each helmet must be equipped with the MCS II Harley Davidson / Honda
Goldwing system.
Warning: Connect the cables so that they are free and do not hinder riding
nor reduce the freedom of movement, and do not wind them around the
Fig. 25
To remove the MCS II from the
helmet, remove the earphone and the
comfort cheek pads as shown in the
assembly operations. Then remove
the polystyrene cheek pads. Remove
the protection plate, then, looking at
the helmet from the outside, release
the connector
fastening clasp as illustrated in the
figure.
by acting on the
17