DOREL Living DA7499E Manual Del Usuario página 11

TWIN/FULL BUNK BED
DA7499E / DA7499W / DA7499G
STEP 4
Attach the support posts (W) to bottom slats (Y) of the bottom bunk with hex socket
head bolts (8) as shown.
Attach a bottom slat (X) to bottom side rails (J) with flat head wood screws (4). Make
sure the slat touches the corner posts (as close to the headboard as possible).
Attach the other slats (X & Y) to the bottom side rails (J) with flat head wood screws
(4) using a Phillips head screw driver (not included). Use space block (A1) to space
them out evenly as shown.
NOTE: If you notice that any of the slats (X & Y) are not perfectly flat, make sure to
assemble them so that the slats (X & Y) curves up in the middle and down on the
ends.