Bios Utilities - Viglen Omnino Serie Guia Del Usuario Concisa

Concise User's Guide

BIOS Utilities

To enter the BIOS Utilities, press F2 when you see the prompt at startup. Screen navigation instructions are in the
box at the bottom of the screen. There is one general rule: Don't make any changes unless you are sure of what
you are doing. Many of the settings are required by the system, and changing them could cause it to become
unstable or worse.
PhoenixBIOS Setup Utility
Main Main Advanced Security Power
System Time [22:01:05] 22
System Date [07/25/2003]
Legacy Diskette A: [1.44/1.25 MB 3
Primary Master 40021MB
Secondary Master CD-ROM
System Memory: 640 KB
Extended Memory 246 MB
Share Memory [16 MB]
F1 Help Select Item -/+
Esc Exit Select Menu Enter
Hyper Threading Technology (Advanced Menu)
Hyper-Threading will be "Enabled" by default if your computer has an Intel Pentium® 4 Processor with Hyper-
Threading Technology (see
Share Memory (Main Menu)
By default, the video memory is set to 16MB. You may also set it to 8MB or 32MB (maximum). This memory is
allocated from your system memory.
26 - BIOS Utilities
Boot Exit
Item Specific Help
<Tab>, <Shift Tab>, or
1 /
"] <Enter> selects field.
2
Change Values F9 Setup Defaults
Select Sub-Menu F10 Save and Exit
"Hyper-Threading" on page
Figure 13
BIOS
Main Advanced Advanced
Screen
Setup Warning
Setting itmes on this menu to incorrect
Examples
values may cause your system to malfunction.
Installed O/S:
Reset Configuration Data:
Large Disk Access Mode:
Legacy USB Support:
OSB Logo Control
USB 2.0 Controller
Hyper Threading Technology
I/O Device Configuration
F1 Help
Esc Exit
27).
PhoenixBIOS Setup Utility
Security Power Boot
Select the operating
system installed
PNP O/S
[ ]
on your system which
[No]
you will use most
[DOS]
commonly.
[Enabled]
Note: An incorrect
[Enabled]
setting can cause
[Enabled]
some operating
[Enabled]
systems to display
unexpected behavior.
Will only appear if the CPU
Note: WinME can not
supports Hyper Threading.
support USB 2.0.
Select Item -/+ Change Values
Select Menu Enter Select Sub-Menu
Exit
Item Specific Help
F9 Setup Defaults
F10 Save and Exit