ASROCK 775XFire-eSATA2 Manual Del Usuario página 7

CAUTION!
1. About the setting of "Hyper Threading Technology", please check page 40
of "User Manual" in the Support CD.
2. This motherboard supports Untied Overclocking Technology. Please read "Un-
tied Overclocking Technology" on page 33 for details.
3. This motherboard supports Dual Channel Memory Technology. Before you
implement Dual Channel Memory Technology, make sure to read the
installation guide of memory modules on page 12 for proper installation.
4. This motherboard supports two Double Sided DIMMs or four Single Sided
DIMMs. For other limitation, please read "Installation of Memory Modules
(DIMM)" on page 12 for details.
5. Although this motherboard offers stepless control, it is not recommended
to perform over-clocking. Frequencies other than the recommended CPU
bus frequencies may cause the instability of the system or damage the
CPU.
6. While CPU overheat is detected, the system will automatically shutdown.
Before you resume the system, please check if the CPU fan on the
motherboard functions properly and unplug the power cord, then plug it
back again. To improve heat dissipation, remember to spray thermal
grease between the CPU and the heatsink when you install the PC system.
7. For the information of the compatible PCI Express VGA cards, please
refer to the "Supported PCI Express VGA Card List for AGI Express Slot
(PCI Express x 4)" on page 8. For the proper installation of PCI Express
VGA card, please refer to the installation guide on page 14.
8. Before installing SATAII hard disk to SATAII connector, please read the
"SATAII Hard Disk Setup Guide" on page 27 to adjust your SATAII hard disk
drive to SATAII mode. Besides, you are allowed to downgrade the SATAII
hard disk to SATA hard disk (from SATAII 3Gb/s down to SATA 1.5Gb/s),
and connect it to the SATAII connector. You can also connect SATA hard
disk to SATAII connector directly.
9. This motherboard supports eSATAII interface, the external SATAII
specification. Please read "eSATAII Interface Introduction" on page 24 for
details about eSATAII and eSATAII installation procedures. (Port Multiplier
Technology is not supported with eSATAII interface on this motherboard.)
10. Power Management for USB 2.0 works fine under Microsoft
SP1 or SP2 / 2000 SP4.
ASRock 775XFire-eSATA2 Motherboard
® ®
Windows XP
7 7 7 7 7