Maintenance And Cleaning; Technical Assistance; Assembly Instructions; Battery Assembly - VITO GARDEN VIBCACSFL20 Manual De Instrucciones

The following precautions and procedures should also
be followed to avoid accidents:
▪ When using the brush cutter, place yourself in a
stable position and always keep your balance. Hold
the brush cutter firmly to ensure continuous
operation and withstand unexpected situations;
When the rotating accessory locks, immediately unplug
the tool.
▪ Make sure that the ventilation grids are not
obstructed during operation. Do not insert any
objects into the ventilation grids;

Maintenance and cleaning

Remove the battery from the power tool before start
cleaning, adjustment, repair or maintenance work.
Replace worn out or damaged parts immediately so that
the power tool is always operational and in safe
operating condition.
Cleaning:
Always keep the power tool clean and dry, free of oil,
grease and lubricants.
accessories of the power tool after use.
Do not use strong cleaning agents. These products can
damage plastics and metals and impair the safe
operation of your power tool.
Maintenance work:
Maintenance work may only be carried out as described
in this instruction manual; all other work must be
carried out by an official distributor.
Keep all nuts and screws tight so that the power tool can
operate safely.
If components or safety devices are removed for
maintenance work, they must be replaced correctly
immediately.
Use only attachable tools or accessories authorized by
VITO for this power tool or technically identical parts.
Otherwise injury or damage to the power tool may
occur. In case of doubt or if you lack the necessary
knowledge and means, you should contact an official
dealer.

Technical assistance

Clean all components and
Your brush cutter should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.

ASSEMBLY INSTRUCTIONS

Battery assembly

1. Insert the battery (3) into the brush cutter fitting and
press the battery until you hear the "click noise" of the
battery lock/unlock button. At this point the battery is
completely secured;
2. To remove, press the lock/unlock button and pull out
the battery;
Only use VITO 20V lithium batteries.

Battery charging

1. Place the battery in the charger as if you placed in the
brush cutter;
2. Plug the charger plug into the outlet and let it charge.
Sometimes at the end of charging, both the battery and
the charger may be hot, which does not mean that they
are malfunctioning.
Allow the battery to cool down before putting it in the
machine.

Blades assembly/replacement

1. Remove 2 blades from the supplied set;
2. Place one blade on each pin;
3. Pull the blades out, making sure they are properly
secured to the pin.

OPERATING INSTRUCTIONS

When working with the brush cutter, you should
consider some precautions and operating procedures:
21