Tabla de contenido
BLADE HOLDER ASSEMBLY
Removal
1.
Remove cotter pin and loosen slotted nut on gearbox shaft. Loosen but do not remove the nut until the
blade carrier is loosened.
2.
Align blade bolt with access hole in top of cutter deck. Use long bar inserted through blade bolt access
hole with end against blade bar. Strike opposite end of bar with sledge hammer. Rotate blade carrier
180 degrees and repeat process.
3308-2 SERIES 09/19
© 2019 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-13
Capítulos
Tabla de contenido
