Electrical Connection; Wiring Diagrams - Cooper Lighting IB520101ML Instrucciones De Instalación

4. The LED module wires are populated in the flexible conduit at the length indicated during order (Figure 2).
5. Run cable to J-box either supporting or connected to the fixture housing, by opening a 7/8-inch knockout and using the
38ast snap in connector provided on the harness (Figure 2).
6. The LED module connector will hang from the J-box (Figure 2).
7 . Refer to the fixture's main instruction sheet to complete fixture install.
Surface Mount J-Box
LED Module Connector
3/8 Inch (38ast) Snap in Connector
Figure 2.

Electrical Connection

Make certain no bare wires are exposed outside of wire nut
connectors.
1. Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C.
2. Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using
properly sized wire nuts. Be careful not to leave any
bare conductors outside of the wire nut connectors.
3. Connect white to white, black to black, and green (from
electrical service) on the supply side to the green wire
in the cylinder housing assembly.
Flexible Conduit
7/8 Inch Hole

Wiring Diagrams

1. For D010TR Driver
BLACK (LINE) BLACK (LINE)
WHITE
(NEUTRAL)
GRN
2. For D010TE Driver
BLACK (LINE)
WHITE
(NEUTRAL)
GRN
Cooper Lighting Solutions
Installation instructions – Remote Driver
BLUE
TRIAC DIMMING RED
@120VAC OR 0-10V
WHITE
@ 120 277VAC
(NEUTRAL)
DIMMING DRIVER
PURPLE
GREY
BLACK
BLACK (LINE)
TRAILING EDGE
RED
DIMMING OR
WHITE 0-10V DIMMING
DRIVER
(NEUTRAL)
PURPLE
GREY
IB520101ML Installation instructions
BLACK
LED
RED
MOUDLE WIRING
DIAGRAM
0-10V
DIMMING
OPTION (FIELD
INSTALLATION)
BLACK
LED
RED
MOUDLE WIRING
DIAGRAM
0-10V DIMMING
OPTION (FIELD
INSTALLATION)
3