Power On/Off - Rollei HS Freeze 6 Manual De Instrucciones

Operation
Power on / off
• Switch on: Press and hold the power button for about 2 seconds until the
LCD screen will light up and enters the operation interface .
• Switch off: Press and hold the power button for about 2 seconds until the
LCD screen will become totally black .
TTL Mode
1 . Enter Menu 1 and press the second function button repeatedly until the display
shows TTL on the LCD .
2 . Press the third function button to change the sync mode . Choose between
normal mode or high speed mode .
3 . Enter Menu 2 to set the channel and the group of the flash .
4 . Choose the wireless remote control mode according to the trigger that you use .
5 . The exposure value can be adjusted from -3 .0 up to +3 .0 directly on the flash by
rotating the power output knob . The value can be adjusted by 1 f-stop increment
by pushing the power output knob once and then turning it around (clockwise
to increase the value and counter clockwise to decrease the value) . But the value
can also be adjusted by 1/10 f-stop by just turning the power output knob .
Note: If you use a trigger the value of the flash will not be overwritten by the value
set on the trigger . For example if your flash shows an EV of +1 .0 and your trigger
shows a value of +2 .0, then the picture will have a real exposure value of +3 .0 .
If the flash shows an EV of +3 .0 then you are able to even get a higher exposure
value by setting the trigger to also +3 .0 and then the maximum exposure value of
+6 .0 will be reached . The same goes for the negative exposure values .
29