Tabla de contenido
CHARGER OPERATION
WARNING
Charge Dranetz BP-HDPQ battery pack ONLY.
CAUTION
Disconnect battery pack from charger after battery pack is fully
charged. Continuous charging of a fully charged battery pack can
degrade battery performance.
The following describes basic operation of the XBC-HDPQ external
battery charger and its applications.
1. Set the charge setting to either 1.0A or 2.0A
1.0A - the battery will fully charge in approximately 2 hours.
2.0A - the battery will fully charge in approximately 1 hour.
2. Connect the battery pack to the 4 pin polarized output plug of the
XBC-HDPQ before powering the external battery charger.
3. Connect the applicable female end of the power cord (US, Euro,
UK, or Australian) to the input power connector of the battery
charger
4. Connect the plug end of the applicable power cord to an
applicable outlet power source.
5. Once the charger is powered the LED illuminates "red "
indicating the battery pack is charging. At the end of the charging
cycle, the LED illuminates "green" indicating the battery pack has
been fully charged.
6. After the battery pack has been fully charged disconnect the
power cord first and then the battery pack from the charger.
7. If charging multiple battery packs disconnect the power source to
the battery charger and then disconnect the battery pack from
the charger for each charge cycle.
Always refer to the applicable User's Guide for additional information
concerning installation, operation, and connections of Dranetz or Original
Equipment Manufacturer's instructions applicable to your installation.
13
Tabla de contenido
