Kenmore 233.5994090 Manual De Uso Y Cuidado / Instalacion página 95

CHANGING BLOWER DISCHARGE (Optional)
The blower is shipped with its discharge facing DOWN. Fol-
low these steps ONLY if:
• the position of the blower discharge needs to be moved
so ductwork does not interfere with floor.joists, plumb-
ing or wiring below.
• it is necessary to rotate the blower discharge to the
RIGHT or LEFT.
Place the unit on its back on a table or work surface.
DOWN DISCHARGE - MOVING BLOWER LEFT OR RIGHT
1. Loosen the 4 nuts and 2 clamp channels.
2. Slide blower to desired position.
3. Use supplied cover plate to close open space (if any).
4. Tighten nuts to secure top of blower and use sheet metal
screws through bottom flange to secure bottom of blower.
LEFT OR RIGHT DISCHARGE
1. Remove the 4 nuts and 2 clamp channels.
2. Carefully lift blower and disconnect motor plug if necessary.
Reposition blower and RECONNECT MOTOR PLUG.
3. Use supplied cover plate to close open space (if any).
4. Replace clamp channels and use nuts to secure the blower
in its new position.
5. Use sheet metal screws through bottom flange to secure
bottom of blower.
SHEET
NUT
BOTTOM
FLANGE
S 8LOWE R
_.__ ,,,/,_ _.
= _ /Y/ MOTOR
jVVl I-- SHEE_
- _ T -"METAL
L-- ",,,, /
_COVER PLATE
2
0
m
J
.
r_l
I
I
J
7