Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12. Carefully lift shingles and nail flashing securely to the
roof using galvanized roofing nails.
13. Using a good grade of roofing cement material, seal
all of the shingles and heads of nails.
DO NOT seal the bottom edge of the flashing.
WIRING
IMPORTANT: Do not mount outlet box near heat source.
1. Mount the outlet box to a nearby rafter so that the outlet
box is higher than the fan motor.
CAUTION: Make sure fan and switches are properly
BLACK
FROM MOTOR
FROM
FAN MOTOR
GROUND
grounded and all wiring complies with local electrical
code requirements.
2. Remove the thermostat wiring box cover plate. Bring
120 VAC, 14-gauge-with-ground house power cable at
least 6" into the thermostat wiring box. Fasten cable to
box with appropriate connector.
3. An on/off switch can be installed in a convenient location
in the living area of the house so that the fan can be
turned off when not needed.
ADJUSTING THE THERMOSTAT
FAN ON TEMPERATURE
80
o
70
o
60
o
50
The fan thermostat is preset to 110
automatically start when the ambient temperature reaches
the set temperature and stop when the temperature
drops 10-degrees below the set temperature. The start
temperature can be adjusted from 60
MODEL 349BR
Page 4
BLACK
FROM HOUSE
CABLE
HOUSE
CABLE
WHITE FROM
MOTOR AND
HOUSE CABLE
o
o
90
o
100
o
110
o
120
F. The fan will
0
F to 120
F.
0
0
Tabla de contenido
