HomeNetWerks 7130-04-BT Manual De Instrucciones página 9

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
5. Mount fan body to the joist or stud using long
wood screws (AA) where indicated by arrows
outside fan body (A).
Hardware Used
AA Long wood screws
6. Pull wire through hole (5.1) and into junction box
(not included). Using quick connector, secure
120-volt AC house wiring from wall switch to fan
as shown in wiring diagram on page 5.
Note: 12 AWG is the minimum conductor to be
used for branch-circuit wiring.
CAUTION: If your electrical wires do not match
the colors listed, you must determine what each
house wire represents before connecting. You
may need to consult an electrical contractor to
determine safely.
7. Install a circular 4 in. duct (not included) and
secure it with duct tape or clamps (neither
included).
Finish ceiling work. Ceiling hole should be aligned
with edge of fan body.
BLUETOOTH SPEAKER FAN GRILLE INSTALLATION
®
Housing must be installed flush with ceiling board or the grille mounting spring will not be long
enough to insert into the slots inside the fan housing.
1. Join the connectors for the BLUETOOTH
speaker and power adapter.
www.homewerksww.com
5
x 2
6
7
®
1
9