Positioning And Handling - MBM WGG74 Manual De Uso E Instalación

If there is a smell of gas in
the environment, it is man-
datory to urgently implement
the procedures described below.
Immediately stop the gas supply
•
(Close the network tap, detail A).
Ventilate the room immediately.
•
Do not operate any electrical de-
•
warn the relevant entities (electric-
ity operator and/or fire-fighters).
Before proceeding with the ope-
rations, see "General safety infor-
mation".
OBLIGATIONS - PROHIBITIONS -
ADVICE
Upon receipt, open the machine
packaging and ensure that the
machine and accessories have
not been damaged during transporta-
tion. Where this is found to be the
case, notify the carrier immediately
and do not proceed with installation
but contact the qualified and author-
ised personnel.
The manufacturer is not liable for
damage caused during transportation.
HANDLING SAFETY /
Failure to follow the instructions re-
ported below could result in expo-
sure to the risk of serious injury.
The operator authorised for the
handling and installation opera-
tions of the appliance must pre-
pare, if necessary, a "safety plan" in or-
der to ensure the safety of the persons
involved in the operations. In addition,
they must follow and strictly and scrupu-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION

POSITIONING AND HANDLING

- 8 -
vice in the environment (Detail
B-C-D).
Do not operate any device which
•
could produce sparks or flames
(Detail B-C-D).
Use a means of communication
•
that is external to the environment
where there is a smell of gas to
lously implement the laws and regula-
tions relating to mobile sites.
Ensure that the lifting means
adopted have capacity that is
adequate for the loads to be lifted and
are in a good state of maintenance.
Perform the handling operations
using lifting means with a capa-
city appropriate to the weight of
the appliance increased by 20%.
Follow the directions on the
packaging and/or on the same
appliance before handling.
Check the centre of gravity of the
load before lifting the appliance.
Lift the appliance to a minimum
height from the ground in order to
ensure its handling.
Do not stand or pass under the ap-
pliance during lifting and handling.
HANDLING - TRANSPORTATION /
- see SECT. IMAGES - REF. b).
The orientation of the packed
appliance must be maintained
according to the instructions
given by the pictograms and lette-
3.