Technical Data Table; Trasformation; Instructions For Installation; Installation - Lotus FTC-4EM Guia Para La Intalación E Instrucciones De Uso

Ocultar thumbs

página de 26

/ 26
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

MODELS

DIMENSIONS cm

POWER SUPPLY

MAXIMUM ABSORPTION A

MAXIMUM POWER kW

POWER SUPPLY CABLE

(Silicone)

DIMENSIONS cm

POWER SUPPLY

MAXIMUM ABSORPTION A

MAXIMUM POWER kW

POWER SUPPLY CABLE

(Silicone)

The data plate is on the front panel (see diagram in electric connection item) and has all the data necessary for the

connection.

When fitting, the appliance must be levelled using a spirit level; slight differences of level can be adjusted by screwing

or unscrewing the adjustable feet. The main switch or the socket must be near the appliance and easily accessible.

It is advisable to place the appliance under an extractor hood so that steam is extracted rapidly. If the appliance is placed

near walls, dividing panels, kitchen furniture, decorative finishing, etc. , these should be in flameproof material;

otherwise it is necessary to cover them with non-flammable material.

Above all, it is necessary to ensure that the fire prevention norms are observed.

The installation, starting up and maintenance of the appliance must be carried out by qualified personnel. All operations

done when installing must be carried out observing the norms in force.

The manufacturer declines all responsibility in the event of incorrect functioning due to wrong installation or

installation which does not comply with the norms.

Attention! In accordance with international rules, when connecting the appliance, an automatic device enabling the

disconnection of all contacts from the mains, must be installed above it; this device must have a contacts opening of at

least 3 mm.

Installation must be carried out observing the following norms:

- Safety prescription in force

- Installation prescription, in force.

The appliance is supplied without the electric connection cable. To install the power supply cable, proceed as follows:

•

Disconnect the power supply.

•

Remove the rear panel

•

Connect the conductor wires to the corresponding terminals in the junction box and fix them into place.

•

Block the cable with the cable blocked, and reassemble the front panel. The earth wire must be longer than the

others so that if the cable blocked should break, it will disconnect after the tension wires.

N.B. The connection cable must have the following characteristics: it must be at least the silicone type (resistant to a

temperature of at least 180°C, and must have an adequate section for the power of the appliance (see technical data

table).