Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Contents
Warnings
1. Product description
2. Installation
3. Electrical connections
8. EC Declaration of conformity
Warnings
The STAR B PLUS control unit has been designed for the con-
trol of a single-phase asynchronous motor used for the au-
tomation of shutters, overhead garage doors, gates, rolling
shutters or awnings.
Any other use is improper and prohibited. The motors must
be equipped with electromechanical limit switches designed
to limit their movement. Keep in mind that these automation
systems must be installed by qualified personnel in compli-
ance with current laws and regulations.
1.
Product
description
The STAR B PLUS control unit enables the control of single-phase
asynchronous motors powered by the electrical mains, with "COM-
MON" "OPEN" "CLOSE" type connections. It is designed for the au-
tomation of shutters, overhead garage doors, gates, rolling shutters
or awnings. The control unit incorporates a radio receiver operating
at a frequency of 433.92 MHz.
Up to 254 transmitters can be memorized.
After each command, the motor is powered for the set "working
time" and programmed during the installation stage. The limit switch
incorporated in the motor stops the movement when the desired po-
sition is reached. The "pause time" can be programmed after which
automatic closure occurs.
The control unit is equipped with a number of inputs used to activate
commands such as "step-by-step", "open", "close", as well as sig-
nals for the triggering of safety devices such as photocells or stop
commands.
1
D
C
B
3
3
3
4
4
A
4
4
5
5
FLASH
C
5
O
6
6
A Line fuse (5A)
6
B "close" relay
6
C "open" relay
D Low voltage transformer
7
E Microprocessor
7
F
Programming dip-switch
7
G "radio" LED
8
H "radio" pushbutton
I
2.
Installation
!
The electrical systems and the automations must be in-
stalled by qualified and experienced personnel in compliance
with current legislation. Before you proceed to make any con-
nections make sure that the mains power supply is discon-
nected.
To proceed with the installation, secure the container as shown in
figure 2. When you drill a hole in the container for installation and
wiring, take the necessary precautions to guarantee the required IP
protection class. The wires must always be threaded from below.
2
E
T2
T1
L N
N
M
I
"stop", "photo" and "step-by-
step" inputs LED
L
Terminal for radio aerial
M "step by step" pushbutton
N Low voltage input terminals
O Line, motor and flashing light
connection terminals
F
G
H
I
L
1
Capítulos
Tabla de contenido
