Instrucciones De Instalación - Master Forge BG179B Manual Del Usuario

INSTRUCCIONES DE INSTALACIÓN
INSTALLATION INSTRUCTIONS
Before Using Your Unit Antes de usar la unidad
• Remove the exterior and interior packing.
• Before connecting the unit to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Ajuste del control de temperatura
Setting the Temperature Control
olo
• Your unit has only one control for regulating the temperature in the compartment. The
en el lado superior del compartimento.
temperature control is located on the upper side of the compartment.
• The first time you turn the unit on, set the temperature control to "7."
• The range of the temperature control is from position "0" to "7." "1" is warmer and "7" is
cálido y "7" es el más frío.
cooler. After 24 to 48 hours, adjust the temperature control to the setting that best suits
your needs. The setting of "4" should be appropriate for normal use.
piada para el uso normal.
• To turn the appliance off, turn the temperature control to "0."
Conexión eléctrica
Electrical Connection
• Turning the temperature control to "0" position stops the cooling cycle but does not shut off
the power of the unit.
• If the unit is unplugged, has lost power or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
Food Storage
Almacenamiento de alimentos
• Wrap food in plastic wrap before storing. Place food evenly on wire rack.
pareja en el estante.
• Let hot food cool down before putting into this refrigerator for saving energy.
• Don't open door frequently.
• Keep space between foods inside refrigerator.
• Keep food dry before storage.
Installing Your Unit
Instalación de la unidad
• Remove food from refrigerator when power is out.
• Place your unit on a floor that is strong enough to support the unit when it is fully loaded.
• Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
• Plug the unit into an exclusive, properly installed-grounded GFI wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours
before placing food into the refrigerator compartment.
4
"1" es el más
-