Palram Feria 3x4.2 Manual Del Usuario página 104

Notes
During Assembly
Use
a
soft platform below the parts to avoid scratches and damages.
Product dimensions
can be
adjusted to your specific
needs:
1.The wall-mounting profile (top-back)
can be
adjusted from 260 to
305 cm
(102.4"
to
120") above ground.
The adjusting
is
done when measuring and drilling (Step
9).
Please
note the installation recommendations' height suggested
in
Diagram
A.
It
is
possible to fix the Patio Cover back wall height at the lowest point of
260
cm/102.4".
This
method
is
optional if
the assembly conditions and exterior walls do not allow to follow the suggested installation
as
appears
in
the manual.
Please
note that the product appearance may slightly change
as
a
result, however snow load weight
does
not change.
2. Poles
distance from the wall
can be
adjusted from 226
to
286 cm (89"
to
112.5")
as
suggested
in
Diagram
B1.
Poles
distance from the side edges can be adjusted from
0
to
54 cm (0"
to
21.3")
as
suggested
in
Diagram
B2.
The adjusting
is
done after assembly and before anchoring (Step 27) by sliding poles and profile 7030 +7031 at the
roof profiles'
channels.
3. Wall mounting and distance from the wall determine the roof angle and the total depth of the product
(distance of
gutter from the wall). Higher wall mounting and shorter distance between wall and poles increase the
roof angle and
shorten the total depth
as
suggested
in
Diagram
C.
Steps
Step
7: Please
apply silicone
sealants on
both
sides
of the part combining 8119
in
order to prevent water leakage.
Step 8: Apply silicone
sealants on the inner part
of 8116 & 8117
and connect to the profile.
Step 16: Please
apply silicone
sealants above beam 7288
+
7289,
in
order to prevent water from seeping
in.
Step 18: Make sure
that the angle between the
back wall profile and the panel supporting
profiles
is
90 degrees.
Assembly of the panels should start from the middle of
the patio cover to
each side alternately.
Step 27:
Please
adjust the poles (inside out and sideways) by sliding them to their final position prior to anchoring.
Make sure that the poles distance from the
Patio cover side edge does
not
exceed
54 cm/21.3".
*Please note: Anchoring this product to the ground
is
essential to
its
stability and rigidity.
It
is
required to complete
this
stage in
order for your warranty to
be valid. (Step 28)
*Tighten
all screws when completing assembly.
Note:
The wall anchoring kit supplied with this product
is
suitable only for concrete
walls.
Other wall types need
an
accordant wall fixation kit.
II
260-305cm
102.4"-120"
B1
226-286cm
89"-
112.5"
0-54cm
0'-
21.3"
.
.
. -
13°
.
+
17°
'..
,..
+
-