Illumina TR-001-44 Guía De Cumplimiento

RFID Reader (Model # TR-001-44) Compliance Guide
The RFID Reader is a compact module designed for use within a host device
for short-range reading of high frequency (HF) tags. The module consists of a
radio module, loop antenna, and a UART host interface on a single footprint of
40 mm x 40 mm x 6.5 mm.
The following figure illustrates the RFID Reader (Model # TR-001-44).
The following figure illustrates the Host UART interface connections.
RFID Reader Specifications
Power
Input Voltage
Supply Current
Electrical
Operating Temperature
Storage Temperature
Radio Frequency (RF)
RF Operating Frequency
RF Output Power
Material # 20000200
Document # 15041950
Specification
2.7–5.5 Volts DC
120 mA
Specification
0°C to 35°C (32°F to 95°F)
-20°C to 85°C (-4°F to 185°F)
Specification
13.56 MHz
200 mW
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following 2 conditions:
1 This device may not cause harmful interference.
2 This device must accept any interference received, including interference
that may cause undesired operation.
CAUTION
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instrumentation
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case users will be required to correct the
interference at their own expense.
NOTE
The antennas used for this transmitter must not be colocated or operating
in conjunction with any other antenna or transmitter.
Host Device Labeling
If the RFID Reader is not visible when installed in the host device, the host
device must include one of the following exterior labels:
} Contains Transmitter Module FCC ID: ZWF-TR00144
}
Contains FCC ID: ZWF-TR00144
IC Compliance
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
This device complies with Industry Canada licence-exempt RSS standards.
Operation is subject to the following two conditions:
1 This device may not cause interference.
2 This device must accept any interference, including interference that may
cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
This radio transmitter (IC ID: 9859A-TR00144) has been approved by Industry
Canada to operate with the antenna types listed below with the maximum
permissible gain and required antenna impedance for each antenna type
indicated. Antenna types not included in this list, having a gain greater than