Ecco Hide-A-LED 9011 Instrucciones De Instalación

The single head (9011) Hide-A-LED ™ concealed warning
light offers high-intensity light output from a tiny package.
Designed specifically to be installed inside vehicle head
and tail lighting, each unit features 16 synchronizable
flash patterns. Options include an in-line waterproof power
module and 9' cable. This manual provides information about
installation, function, safety, maintenance, replacement parts
and warranty.
IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be delivered to the end user.
!
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property damage, serious
bodily/personal injury, and/or death to you and those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understand the safety
information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are
essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he can
operate the system without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the
vehicle operator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks
or compartment doors), people, vehicles, or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an
intersection, driving against traffic, responding at a high rate of speed, walking on or around traffic lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying
all laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and
regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.
Specifications:
BLUE, CLEAR, GREEN, PURPLE
Input Voltage: 10 to 30 VDC
Input Current: 0.5A @ 12.8V, 1.0A @ 12.8V
Lumens: Blue 155+
Green 200+
Clear 660+
Purple 660+
RED, AMBER
Input Voltage: 12.8V (10 to 16 Vdc)
Input Current: 0.35A
Lumens: Amber 160+
Red 123+
SPLIT COLOR
Input Voltage: 10 to 30 VDC
Input Current: 0.5A
Lumens: Half of value shown above per side
920-9061-00 Rev. D
Installation Instructions
9011 Wide Angle Hide-A-LEDs
Dimensions:
1.28"
0.93"
1.50"
0.150"
0.980"
1.50"
Page 1 of 4