Forward/Reverse Switch - Promaker PRO-TP800 Manual Del Usuario

WARNING: To avoid fire or
toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner
or similar highly volatile solvents
to clean the tool.
ASSEMBLY AND OPERATING

FORWARD/REVERSE SWITCH

The forward/reverse switch (1) is
conveniently mounted in front of
the trigger switch (2) (Fig. 1). To
make the drill rotate clockwise for
drilling, push the forward/reverse
switch to the right. To make the drill
rotate counter-clockwise, push the
forward/reverse switch to the left.
NOTES:
a) Never change the position of the
forward/reverse switch while the
chuck is turning.
b) There is no dead center position
for the forward/reverse switch. The
tool will run only when it is in either
the full left or full right position.
VARIABLE-SPEED TRIGGER SWITCH
This drill is equipped with a variable-
speed ON/OFF trigger switch.
1. To start drill, gently squeeze
the trigger switch (2) (Fig. 2).
NOTE: The drill will turn at its slowest
speed when the trigger switch is
depressed slightly. The drill will turn
at its fastest speed when the trigger
Fig.1
switch is fully depressed.
2. To stop the drill, release the
trigger switch.
NOTE: Drilling at a slow speed for
an extended period of time may
cause the drill motor to overheat. If
drill gets hot, stop drilling and allow
it to cool for at least 15 minutes.
INSTALLING DRILL BITS
Fig.2
Fig.3
9