Atlantic CB30R4 Manual Del Producto página 3

Plumbing Copper Bowls
Copper Bowls all feature dual inlets in the base of the bowl, one at center, one off center. The
center inlet is typically used for incoming water flow. Minimum 1½" I.D tubing is required for
optimal water flow. With the empty bowl upside down, attach a 1½" male threaded fitting of
your choice to the 1½" female threaded inlet using thread sealant or silicone on the threads.
Thread the fitting into the inlet by hand until tight and finish off with a half turn from a wrench.
If using the Pedestal under the Fountain or Spillway Bowls, pass the 1½" supply line through
the center of the Pedestal before connecting the supply line to the Bowl. Connect the supply
line from the pump to the fitting on the bottom of the Copper Bowl. Set the bowl right side up
on the base of your choice, adjust the supply line as needed and check for level. Shim as
needed to ensure Copper Bowl is level in all directions.
Installation of CSEAL15 Cord Seal Fitting
If a light inside the Bowl is desired, the Cord Seal
Fitting (CSF) allows the light cord to pass out of the
Copper Bowl (or any other basin) through the
unused 1½" female threaded inlet, underwater, without
leakage. The CSF installs inside any 1½" Sch40 female
socket, so the first step is to install the 1½" Sch40 PVC
male thread adapter that is included with the CSF. The
male thread adapter can be installed either inside the
Copper Bowl or underneath if ample clearance
is provided. Follow the instructions included with the
Cord Seal Fitting to complete installation.
Maintenance
Atlantic Copper Bowls and Pedestals are treated with a light lacquer coating to maintain their
copper sheen until installation but will develop a natural patina when in use. The patina needs
no maintenance. If you would like to maintain the original appearance over time, periodic
cleaning/polishing with a non-abrasive copper cleaner will be required.
Winterization
Atlantic Copper Bowls are self-draining for easy winterization in cold climates. Turn off the
pump and remove the standpipe. Remove the pump and store it indoors for the winter. Ensure
that the supply line is fully drained and plug the opening so water will not refill the plumbing.
The small amount of water left will not affect the bowl and may freeze in place. Remove the
plug or Cord Seal Fitting (if utilized) in the other inlet so that the bowl will be able to drain.
Winterize your Basin in accordance with best practices.
Warranty
Copper Bowls and Pedestals carry a three-year warranty. This warranty is extended solely to
the original purchaser commencing from the date of the original purchase receipt. The
warranty is void if this product is used under any condition other than those for which it is
specified. This warranty excludes labor / costs of labor for removal or installation of any
product. Please note the patina is a natural process that will occur and is not covered under
the warranty.
3