Invacare InTouch Stabilite Instrucciones De Armado, Instalación Y Operación página 7

Modification for approximately 1-inch of obliquity
NOTE: This modification can be done on either side of the cushion.
1. Determine which side of the cushion needs to be lowered.
2. Remove the cushion from inner and outer covers. Refer to Removing/Installing the Cushion Covers
on page 4.
3. On the side of the cushion that needs to be lowered, remove the obliquity insert by pulling on the
tab.
4. Align the chamfered edges on the obliquity inserts as shown in DETAIL "B" of FIGURE 5.
5. Put the obliquity insert removed in step 3 onto the obliquity insert that is in place on the cushion as
shown in DETAIL "B" of FIGURE 5.
6. Apply pressure along the hook and loop strip. Pull on the tab to make sure that the obliquity inserts
are securely in place before installing the covers.
7. Install the cushion into inner and outer covers. Refer to Removing/Installing the Cushion Covers on
page 4.
Bottom of cushion
DETAIL "A" - MODIFICATION FOR APPROXIMATELY
½-INCH OF OBLIQUITY
NOTE: This modification can be done on either side
of the cushion.
Remove one obliquity insert for ½-inch modification
Bottom of cushion
Part No 1141448
Top of cushion
Hook and loop strip
Top of cushion
FIGURE 5 Modifying the Cushion to Accommodate Obliquity
Tab
DETAIL "B" - MODIFICATION FOR APPROXIMATELY
NOTE: This modification can be done on either side
of the cushion.
Put the obliquity insert removed in STEP 3 onto the obliquity
insert in place on the cushion for 1-inch modification
Hook and loop strip
Tab
Tab
7
Tab
Obliquity Inserts
1-INCH OF OBLIQUITY
InTouch™ Stabilite/Stabilite OM Cushion
Bottom of cushion
Align the
chamfered edges of
the obliquity inserts
Top of
cushion