Metra Electronics 95-HDIF Instrucciones De Instalación página 3

6. Remove (4) connectors attached to the
fairing support brace by sliding them
off. (Figure E)
7. Remove (2) screws securing each fairing
support brace; 3/16" Allen screw towards
the inside, T25 Torx screw towards the
outside. (Figure F)
FAIRING DISASSEMBLY
(Figure E)
(Figure F)
(CONT.)
8. Remove the ignition switch and locking
collar. (Figure G)
a. Turn the forks to the right, then put
the key in the ignition.
b. Using a panel tool, slightly lift up
the switch to access the release
button underneath. (see inset)
c. Push the button and turn the key
slightly to the left. This should
release the switch.
d. Using a 7/8" open ended wrench,
remove the locking collar, then the
spacer below it.
Continued on the next page
(Figure G)
REV. 6/2/2020 INST95-HDIF
3