Fastening Of Control Bolt - SATA 96442 Manual Del Uso

then restore to the torque value you normally need.
For example: the screw shall be tightened to 50N.m according to the
process requirements of station. First adjust the scale to about
55N.m (more than 5-10% of 50N.m), restore the 50N.m
scale and then tighten it normally.
Pay attention to the units of measurement on the scale (N.m
or lbf.in/lbf.ft)
- Push in the lock nut to lock the torque.

Fastening of control bolt

- Torque wrench applies for fastening the right-handed and left-handed
bolts
The direction of tightening is indicated by the arrow on the torque wrench.
The direction is switched as follows depending on the model:
- Replaceable square head
Press the protruding square driving head with finger, remove the
mushroom head, flip the torque wrench and then fit the mushroom head.
The interchangeable head or wrench shall be provided with the exchange
head produced by the manufacturer to ensure the transmission of
accuracy. Press the spring pin when replacing the wrench head to remove
and assemble the wrench head of your desired size.
- The suitable accessory or sleeve is provided for the connection of screws.
- Connect the wrench and sleeve vertically to the bolt .
Note!
Avoid the tilting and slipping, the extension bar shall be connected to the
bolt as close as possible
- Hold the handle with one hand or both hands to operate the torque
wrench while smoothly applying force along the direction of arrow until a
sound signal is released.
The setting of torque has been reached at this time.
96442-96449/
96421-96430
- 10 -
EN DE RU KO PT JA ES