Fault Finding - Dimas CLEAN F Manual De Instrucciones

Repeat the operation once or twice
depending upon how dirty the sponge is.
For maximum cleaning plunge the pump
into a container of fresh water.
Store in a safe place, out of the reach of
children.
Take care of the tools.

FAULT FINDING

In the event of faulty operation refer to the tables
below to find a solution.
• The machine does not work
CAUSES
Not plugged
properly or
damaged
No mains voltage
Switch defective,
motor cable damaged
Motor faulty
power, unpleasant
smell)
• Difficult starting
CAUSES
Single phase motor
starting condenser
14 Important advice
• Tighten all the nuts and bolts regularly.
• When storing the machine, we recommend
removing the blade and storing it carefully.
• Check that there is sufficient water supply during
operation.
• Tighten the blade firmly.
• Make sure the contact faces of the flanges, blade
and axle are clean.
20
REMEDIES
in - Make sure that the
cable supply is correctly
plugged in (plug,
extension lead, etc)
- Check the supply
cable
- Test or have tested
by an electrician
(circuit breaker, plug,
etc)
- Have tested by an
electrician or contact
the
department
(no - Contact the service
department to have
the motor replaced
REMEDIES
- Replace the
condenser
15
S
A
V
16
For rapid delivery of spares and in order to avoid
any wasted time, it is necessary to remind your
supplier of the details shown on the instruction
plate on the machine with each order, as well as
the reference of the part to be replaced.
Item number
service
17
• Main materials :
* Motor :
* Machine : Aluminium sheet (AC),
The instructions for use and spare parts found in this
document are for information only and are not binding.
As part of our product quality improvement policy, we
reserve the right to make any and all technical
modifications without prior notice.
The manufacturer
responsibility for loss or damage
resulting from
modification, alteration or powering
that does not conform to the
manufacturer's original specifications.
The noise level of this machine is
measured according to the S 31.069
standard.
At the work station, the sound
pressure level may exceed 85 db (A)
In this case individual protection
measures must be taken.
Repairs
Contact your supplier who is entirely at
your service to carry out repairs in the
shortest time at the best possible price.
Spare parts
00000000 (0)
See exploded view
Scrapping
In the event of deterioration and
scrapping of the machine, the
following items must be disposed of
in accordance with the requirements
of the legislation in force.
Aluminium (AL), Steel (AC),
: Copper (CU), Polyamide (PA)
Steel (AC)
declines all
misuse or any
Quantity