Install the glass hold down plate (N) by inserting the allen screw (O) though the
Step 12
glass hold down plate (N) and the shelf bracket (M) and threading the 1/4-20
O
hex nut (P) onto the threaded end of the allen screw (O). Install both screws
leaving glass hold down bracket (N) loose enough to accept the glass shelf (Q)
between it and the shelf bracket (M).
N
Repeat for remaining two glass hold down plates (O)
P
Step 13
Slide glass shelf (Q) onto shelf bracket allowing glass to engage under glass hold
down plate (N). Allen screws (O) will act as a stop for glass shelf (Q). Once glass
shelf if positioned, secure allen screws (O) using provided allen wrench (S).
FIG 1: Use wire management covers (R) on back of wall system support tube.
Step 14
Feed wiring into channel and lock into place by snapping management covers
into place.
TIP: If your power source is below or above shelf system, you must feed single
power cord through the wall plate (A) prior to installation of support tube assem-
bly (STEP 10).
FIG 2: The wall plate covers (K) have a "slide out" tab that allows you to route
wiring out the top or bottom of the shelf system.
Step 15
