Uline H-2805 Manual Del Usuario página 4

7. Set the unit upright and tighten all nuts and bolts
around the entire unit.
8. Insert the shelves (4) at
desired levels.
(See Figure 7)
NOTE: To place
the shelves, tilt the
shelf slightly to the
left or right before
inserting into the
unit.
8
9. Attach the left door (8) to the unit by placing the
door on the hinges, aligning the hinge holes,
dropping the hinge pins into the slots, then placing
the flat end of a screwdriver on the hinge pins and
tapping them in with a hammer. (See Figure 8)
10. Attach the right door (9) to the unit in the same way
the left door was attached. (See Figure 9)
NOTE: If having
issues with doors
aligning, it may be
due to cabinet not
sitting level. Use
included nut driver
to adjust leveling
feet in bottom
front two corners.
Nut driver should
insert through
inside of cabinet
down into feet and
adjust as needed.
PAGE 4 OF 12
ASSEMBLY INSTRUCTIONS CONTINUED
Figure 7
4
Figure 8
15
Figure 9
9
1-800-295-5510
HANDLE/LOCKING SYSTEM INSTALLATION
Figure 10
2. Turn the handle to the
open position. Place
the locking cam (12)
over the square shank
of the door handle.
The latch must be
facing downward as
shown. (See Figure 11).
Place the cotter pin (13)
through the hole of square shank. (See Figure 12)
3. With the handle still in the open position, hook the
locking bars (10) to the locking cam (See Figure 13)
Once in position, slowly rotate the door handle to
the closed position so the lock bars protrude from
the holes at the top and bottom of the door.
4. Slide the nylon lock bar guide inserts (14) over the
lock bar ends and through the door slots. Push firmly
until the guides snap into place. If necessary, turn
the handle back to the open position and gently
tap with a hammer until the guides slide into place.
(See Figure 14)
Figure 13
10
12
uline.com
1. Place the locking handle (11)
on the right hand door and
fasten with two #8-32 x 1/4"
slotted hex-head bolts and
lockwashers. (See Figure 10)
11
Figure 11
13
12
Figure 12
14
14
Figure 14
1120 IH-2805