Courtyard Creations RUS415W Manual De Montaje página 5

Step 11:
Insert seat arms (#8 and #9) into seat supports
(#10 and #11) and fasten them together by using
plastic joint covers (#29), bolts (#18), washers
(#21), and plastic nuts (#26).
See Fig. D – Step 1.
Note:
1. The label marked "back" on the right seat arm
(#8) should coincide with the label marked
"back" on the seat rear support (#11).
2. The clip holder side of the seat rear support
(#11) must face toward the inside of the swing
and the opening side of the clip holder must
be facing upward.
Step 12:
Open the seat assembly (#12) and fasten its
back to seat arms (#8 and #9) by using bolts
(#19), washers (#22), plastic washers (#30), and
jam nuts (#24). Repeat the same procedure for
both sides. See Fig. D – Step 2.
Step 13:
Make sure that the support brace on the seat
assembly (#12) is fully inserted into the clip
holders on the seat rear support (#11).
See Fig. D – Step 3.
Step 14:
Attach the swing arm tubes (#13) to seat arms
(#8 and #9) by using bolts (#17), washers (#21),
and plastic nuts (#26). Repeat the same
procedure for both sides. See Fig. D – Step 4.
Step 15:
Hook the suspension springs (#23) into the top
of both holes in the swing arm tubes (#13).
Repeat the same procedure for both sides.
See Fig. D – Step 5.
V-3
Step 1
Step 2
Step 3
Support
Brace
Step 4
13
8
Step 5
Fig. D
STOP DO NOT RETURN TO THE STORE!
PAGE 5 OF 7
8
21
18
11
10
19
22
30
22 24
13
9
23
23
13
29
26
21
9
8
12
12
11
26
21
13
13
17
21
21
23
13
13
9
21
17
26
23
13