Lithonia Lighting OLAL2 Instrucciones De Instalación

Protect yourself. Before installing, read the entire instructions
carefully and save them for future reference.
Date installed:________________________________________
FIXTURE PACKING LIST
Description
1) Housing Assembly ............................................................... 1
2) Photocontrol ........................................................................ 1
3) 1" Bolts* ............................................................................... 2
4) 2" Wood Screws* ................................................................. 3
5) Cover Plate* ........................................................................ 1
6) Wire Nuts* ........................................................................... 3
7) Diffuser* ............................................................................... 1
*Contained in parts packs
Mounting Hardware Included
Waterproof Supply Fittings & Conduit
will be required - Purchase Separately
Silicone Sealant Required
REQUIRED TOOLS:
Dusk to Dawn LED Area Light
Model Number(s):
OLAL2
INSTALLATION INSTRUCTIONS
If this fixture fails to operate properly, use the guide below to
diagnose and correct the problem.
Trouble Shooting Guide
• Verify that power is turned on at switch and breaker
• Verify that fixture is wired properly
• Verify that line voltage is correct.
Quantity
• Test if Photocontrol works properly
The photocontrol in this fixture is designed to turn on fixture
light at low light levels.
If light does not come on or stays on:
Test if Photocontrol works properly:
• Cover Photocontrol - Light should come on.
• Shine a flashlight into Photocontrol - Light should go off.
If fixture cylcles on and off:
Light reflecting back off any surrounding surfaces enters the
photocontol. To correct problem, reposition the fixture or eliminate
reflective surface.
If further technical assistance is required, contact: Technical
Support at: (800) 748-5070
This LED light provides low maintenance service with no bulbs
to change. Clean surfaces with mild soap and water. Do not use
abrasive materials such as scouring pads or powders, steel wool
or abrasive paper.
WARNING: There are no user serviceable parts inside fixture.
page 1
UOLAL2_Rev 6/14