Controls And Functions - mixars LTA Manual Del Usuario

Accessories and specifications
Check for the following parts included in the package with the main unit:
Instruction manual x 1
Counter weight x 1
RCA Cord X1
Specifications
Power Supply
Power Consumption 10Watts
Dimensions
Weight

Controls and functions

1. Phono / Line output
Connect the turntable to any phono or line level input,using the supplied cinch/cinch cable. Be sure
to put the phono/line switch in the right position.
2. Phono / Line switch
Depending on the position of the phono/line
switch, you can connect the turntable to any
phono or line level input.
3. Additional Line output
Secondary line-level output.
4. Power cord connecter
Used to connect the included power cord.
5. AC voltage selector
Make sure the selector is set properly.
6. Counterweight
Adjustment creates the proper downward pressure
of the stylus to the record. Attach by sliding the
counterweight onto the rear of the tone arm. Twist
it lightly and it will screw onto the rear shaft of the
tonearm.
7. Tonearm height adjustment
Adjust the hight of the tonearm.
8. Anti skate knob
(Only applies on "S" tonearm)
When a record is playing, a force is generated
drawing the stylus towards the center of the
record. This control compensates for that force
and needs to be set to the same value as the
counterweight pressure ring.
9. Tonearm lift
This elevates the tone arm above the record
surface.
10. Tonearm clamp and rest
Use this rest for the tonearm and clamp it in
position during transportation.
11. Pitch select
Sets the adjustment range of the pitch slider.
Press the button to switch between
+/-8%, +/-16% and +/-50% pitch.
Headshell x 1
Target light x 1
45 rpm adapter x 1
AC 115/230V, 60/50Hz
450 (W) x 353 (D) x 144.6 (H) mm
10 Kg
AC cord x 1
Platter x1
Slipmat x 1
12. Tonearm
13. Headshell locking nut Attach the headshell by inserting it into the front
EN 2
end of the tonearm and then turn the locking nut
clockwise.
14. Pitch slider
Use this to change the speed of the platter.
15. Quartz lock
on - will hold the speed at 0%
off - will allow the use of the pitch adjust.
16. Reverse button
This button is used to reverse the direction of the
platter rotation.
17. Motor start / brake adjustment
Adjust the starting and braking time of the motor
by turning the control clockwise for a longer start
or stop time and counter-clockwise for the fastest
start or stop time.
18. Target light
Insert target light to the deck and it will light up.
19. Platter speeds
33 rpm and 45 rpm.
20. Start / stop button
Press the button to start / stop the turntable.
21. Power switch
This switch turns the power on or off.
22. Platter
23. 45 RPM adapter
Place on center spindle for playing 7" records with
large center holes.
EN 2