Installing The Drain Plumbing; Gravity Drain - Marvel MA15C Serie Instrucciones De Instalación, Operación Y Mantenimiento

CAUTION
!
Failure to use an adequate drainage system, will result in
surrounding water damage and/or poor ice production.
WARNING
!
Electrical Shock Hazard
Reasonable care and safe methods should be
practiced. Do NOT work with energized electrical
equipment in a wet area. Read and follow the
installation instructions listed in this manual.
Drain Plumbing
Your ice machine requires drain plumbing. There are 2
variations of ice machines in regards to the installation of
the drain plumbing, without a drain pump (gravity drain),
and with a drain pump.
Gravity Drain (no drain pump):
The ice machine is shipped with the drain line installed,
coiled and secured to the back of the cabinet as shown
in Figure 7. It can be uncoiled, routed to an appropriate
drain and cut to length as required. Additionally there is the
provision of drain routing through the cut-out in the bottom
of the unit, (see the gray area in Figure 8). A drain can be
installed in this gray area with the drain line cut to a short
length and positioned into the drain as shown in Figure 9,
or if the ice machine is to be built-in, the drain tube could be
below.
CAUTION
!
The gravity drain line must be routed no higher than 6"
Figure 7
Uncoil the drain line, route
to an appropriate drain and
cut to the required length

INSTALLING THE DRAIN PLUMBING

Drain line coiled
and secured to
the back of the
unit
CAUTION
!
Observe and follow all local building codes
when installing this ice machine and drain
lines.
Figure 8
Drain access in
bottom of unit
2 1
5 " (13 cm)
1
8
21 "
1
2
(54.6 cm)
Drain tubing, cut
to length and
install in the drain
Figure 9
6
C L
1
"
11
(3.2 cm)
16
(17mm)
4 "
3
32
(10.4 cm)
"(5.7 cm)
4
(37.8 cm)
4 "
17
32
(11.5 cm)
Drain pipe, (not
provided)
Sanitary
trap
Water
supply
inlet
"
1
4
C L
14 "
7
8
Access
panel