General Maintenance - Spyker Spreaders ROS 5 S100-12011 Manual Del Operador

Maintenance
WARNING: AVOID INJURY! DISCONNECT THE SPARK PLUG WIRE TO PREVENT THE ENGINE
FROM ACCIDENTALLY STARTING BEFORE PERFORMING ANY MAINTENANCE ON THIS MACHINE.
A. GENERAL MAINTENANCE
1. Never allow untrained personnel to service machine.
2. If the machine must be tipped on its side for
maintenance, do not tip more than 45 degrees. This
will prevent hydraulic oil from draining out of the
Transmission Hydraulic Tank Breather Cap. Before
tipping machine, drain the fuel from the fuel tank,
and the oil from the engine's crankcase.
3. Be careful not to spill oil on any of the belts.
4. Ensure unit is properly supported by jack stands.
5. Do not tamper with the engine's governor settings.
They are adjusted to provide the proper maximum
engine speed.
6. If the machine is to be in storage for more than 30
days, drain the fuel tank, run the engine to drain the
carburetor dry, change the oil, remove the spark
plug and pour a teaspoonful of oil into the cylinder.
Pull the starter rope briefly to crank the engine and
distribute the oil, then replace the spark plug.
7. Keep all parts in good working condition & all
hardware tightened. Replace all worn or damaged
decals.
B. DAILY MAINTENANCE & STORAGE
AFTER SPREADING
1. Park the machine on level ground outside the
storage facility with the engine shut off.
2. Close the fuel shutoff valve.
3. Permit the machine to cool.
4. Disconnect the spark plug wire.
5. Wash the machine off with water. Be sure to clean
out materials from under the hopper. Allow the
machine to dry before storing.
1017459 Rev. C
6. Check the fuel level, the engine oil level & clean the
cooling-air intake.
7. Clean air cleaner element.
8. After the first 5 hours of use, change the engine oil.
(Change the oil every 50 hours thereafter).
9. Follow Maintenance Table found in the engine
manual.
10. Place the machine in locked storage to avoid
tampering or use by an untrained operator. Do not
store near flame.
C. MAINTENANCE EVERY 50 HOURS
1. Change the engine oil. (Change the engine oil more
frequently under severe operating conditions).
2. Clean spark plug and check the spark plug gap.
3. Clean air cleaner element.
4. Check that all nuts, bolts and screws are tight.
5. Check the condition and tension of trans-axle belt.
The idler pulley should be adjusted so that a 5 lb.
pull on the belt between the engine pulley and the
pump pulley deflects the belt about 3/16".
NOTE: It may be necessary to remove
the skid plate and skid plate hardware to
properly adjust the idler pulley. If the skid
plate is removed, save the hardware and
skid plate for replacement after the
adjustment is complete.
10
©2016 Spyker Spreaders/A Brinly-Hardy Co.