Waring Commercial CTS1000 Manual Del Usuario página 5

OPERATION INSTRUCTIONS
CTS1000/CTS1000CND
there are four unattached feet. each has a screw protruding from
the top for assembly. Locate the four screw holes at each corner
of the bottom housing. Insert the screw and turn clockwise until
snug. Repeat for remaining feet.
Initial Preparation
1. Place Waring Commercial Conveyor toaster on level
®
countertop with a minimum of a 2" clearance between
the side and back walls.
NOTE: If unit is not seated properly, the feet are adjustable for
balancing.
2. Remove all parts (reflector/crumb tray and toast drawer) and
clean thoroughly before first use.
3. Replace all parts and plug unit into appropriate outlet
(see previous page).
4. Switch unit to the oN position. the red PoWeR oN
indicator light will illuminate.
IMPORTANT: Make sure the standby switch is in the full power
position (to the left).
5. When conveyor toaster is ready for toasting, the green
ReADy indicator light will illuminate. this should take
approximately 5 minutes.
6. turn the conveyor speed control knob to set the desired
toasting speed and shade.
7. When the main power switch is turned to the oFF
position, the cooling fan and green ReADy indicator light
may stay on up to 15 minutes for cooling.
Toasting
8. Place bread, bagel or muffin to be toasted on wire
bread feeder. the conveyor toaster will automatically pull
bread into the toasting chamber at the speed set by the
conveyor speed control knob.
9. When complete, toast will slide down bread chute into the
toast drawer.
7
10. If toast is too light or too dark, adjust the speed control.
turn the knob to the right for lighter toasting. turn the
knob to the left for darker toasting. For best results, use
day-old bread stored at room temperature.
Standby Function
11. During long periods of inactivity, the standby switch can be
used to decrease the unit to ¼ power. the switch is found
below the conveyor speed control knob and should be
switched to the right to activate this feature. this is done to
save power and energy during idle periods and extend the
life of the toaster's components. When full power is needed
once again, switch back to the left and allow 3 to 4 minutes
for unit to heat up again. the green indicator light will
illuminate when unit is ready to toast.
CTS1000B
Initial Preparation
1. Follow instructions 1 through 3 in previous section.
2. turn the unit to the desired function by twisting the function
knob located at the bottom of the control panel. the red
PoWeR oN indicator light will illuminate.
3. When conveyor toaster is ready for toasting, the green
ReADy/Hot indicator light will illuminate. this should take
approximately 5 minutes.
4. turn the conveyor speed control knob to set the desired
toasting speed, 1 being the fastest speed and 9 being the
slowest.
5. turn the power control to the desired setting, 1 being the
lightest setting and 9 being the darkest setting.
6. the darkness of your toast/bagel will depend on how hot
and how fast you select your controls.
7. When selecting the bagel function, only the bottom elements
will operate.
Toasting
8. Place bread, bagel or muffin to be toasted on wire bread
feeder. the conveyor toaster will automatically pull bread
into the toasting chamber at the speed set by the conveyor
speed control knob.
8