Valore VS1205 Guía De Instalación Del Usuario página 12

This section will help you measure the
required length of the Main PVC Supply Line
(Part 8) relative to the final position of the
Template Guide
Steps:
• Measure the distance between the bottom of
the template to the closest approximate hole
position on the top of the template which
corresponds to where the shower outlet pipe
is. Refer to this distance as "d1".
• Add 1 inch to your "d1" measurement.
• Using the length of "d1" as a guide, measure
this length on the Main PVC Supply Line Hose
(Part 8) and shear the excess length from the
hose.
Connecting the elbow connector assembly to
the main PVC supply line:
1. Insert the ring clamp (part #7) onto the main
PVC supply line (part #8).
2. Insert the Elbow Connector (Part 3) into the
top-end of Main PVS Supply Line now fitted
with the Ring Clamp.
3. Use the ring clamp (part #7) and tighten in a
clockwise motion. The area that needs to be
tightened is where the main PVC supply line
and the elbow connector joint meet.
If not tightened correctly, this may cause
leaking.
English
INSTALLATION
Draw a level horizontal line based on
5
the lower-edge of the selected hole
6
7
8
4
7
8
4
7
8
12
8
Shear
1
4
3
7
8
2
3
3
3
+
PH