Charging & Usb Connection; Turning On The Boomboom 250; Pair /Connect With Bluetooth - Marmitek BOOMBOOM 250 Modo De Empleo

CHARGING & USB CONNECTION
x Charge the built-in rechargeable battery using the USB cord (included)
connected to your computer OR connected to the USB-to-AC power
adapter (included) and a wall power outlet.
x When connected to a power source via the USB connection, the Battery
will indicate the power status. IF not connected, the LED will NOT
indicate the power status. A RED LED indicates charging is in progress.
x If the battery becomes low, the red LED lights up every 4 seconds, and
a warning signal sounds. Charge PowerBoom as described above.
NOTE: BoomBoom 250 can charge while playing audio. Be sure to plug
the USB into the desired power source prior to playing audio or unit may
need to be restarted
NOTE: The maximum battery life becomes available after about 10
charge cycles.

TURNING ON THE BOOMBOOM 250

Press the ON/OFF switch (C) for 4 seconds until an ascending tone
sounds. The BoomBoom 250 is now on and in standby mode. The
Bluetooth function is now active and the status LED flashes blue rapidly.

PAIR /CONNECT WITH BLUETOOTH

x
Find & enable the Bluetooth Section on your Smartphone/Audio
Device and select the option to "Search for a Device" to search for
Bluetooth signal.
x
After the power is on, wait approximately 3 seconds. The Blue LED
starts blinking.
x
Find 'BoomBoom 250' as a selection on your Smartphone/Audio
Device. Select 'BoomBoom 250' in order to pair with the BoomBoom
250 unit.
NOTE: to indicate successful pairing, the quick flashing blue LED on the
top panel will turn solid blue.
x
Find your music section on your device, press PLAY & LISTEN to your
music!
NOTE: Press the ON/OFF switch (C) if the unit is paired and you want to
pair to another device.
6 © MARMITEK