WorkPro 0055268 Manual De Usuario página 3

ASSEMBLY INSTRUCTIONS
1
C
F
1. Insert all 4 protective covers (F) to bottom
posts (C).
Note: Do not omit this step, which could protect
your floor from scratches.
3
C
B
A
3. Repeat the previous step 2 to attach beams
(A) and brace (B) to bottom posts (C) until
the first level is assembled.
Note: Each of the beams (A) and braces (B)
on the same level should be at the same
height.
2
C
2. Slide the rivets of brace (B) into bottom posts (C)
of your desired location with the key slot pointing
down and shelf ledge of brace (B) facing up. Tap
lightly to seat rivets.
Note: Make sure all the rivets are fully seated into the post slots.
You may turn to a rubber mallet (not included) for achieving this
target. This applies to all the rivets used in this unit.
4
C
B
4. Repeat the previous two steps to attach
beams (A) and braces (B) to posts (C) until
the first two levels are assembled.
3
C
B
A