Broan Best IS241 Manual De Instrucciones página 8

MOUNT HOOD TO SUPPORT
FRAME
1. Fix controls to the control box inside the
lower section of decorative flue by means of
the 2 screws (1/8x1/4"). Put the cover on the
control box.
2. Fix the control box to the blower housins by
means of the 2 screws (1/8x3/8") and 2
serrated washers.
Three people are required to perform the
following operations.
3. Install the hood to support frame by 4 screws
(use the screws removed beforehand - 1/8"
x 3/8").
4. Install the halogen lamps and the grease
filter.
5. Make electrical connections (refer to the
section "WIRING".
6. Remove the temporary fixing screw of the
lower flue section and lower it in place on
the hood.
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical codes.
1. Remove the wiring box cover. Remove a
knockout from the wiring box.
2. Secure the conduit to the wiring box
through a conduit connector.
3. Make electrical connections. Connect white
to white, black to black and green to green.
4. Replace wiring box cover and screws. Make
sure that wires are not pinched between
cover and box.
TOOTHED
WASHERS
WIRING BOX
COVER
- 8 -
CONTROLS
SCREWS
(1/8X1/4")
SCREWS
(1/8X3/8")