Arrow GT12M MINIPLUS Manual Del Usuario página 7

B. For cordless use – Unfold the base stand with the silicone glue pad positioned
below the glue gun nozzle. Align the end of the glue gun handle into the
custom fitted prongs of the base stand and slide glue gun into the charger base
stand as far as possible. Plug cord into the back of the glue gun base stand and
plug the other end of the power cord into the electrical outlet. Press the glue
gun on/off switch to the ON position (I) (DOWN), work light will illuminate
and preheat three (3) to five (5) minutes. After hot glue reaches working
temperature, take glue gun out of the base stand and direct glue gun nozzle
toward target area, squeeze trigger to apply melted glue. Use the cordless
glue gun for up to five (5) minute intervals before returning the glue gun to the
base to re-heat an additional one (1) to two (2) minutes. Repeat intervals of
use during cordless glue gun application and reheat on base stand throughout
project as needed. Return the glue gun to base stand after use.
STEP 3
When first using your new glue gun it will take one (1) stick of glue to fill the melt
chamber before glue begins to flow out.
If, when squeezing trigger, glue does not enter gun easily, DO NOT continue to
squeeze trigger. Glue chamber may not be hot enough to melt glue fully.
Excessive squeezing of trigger may cause hot glue to back up and flow out of rear
of gun, possibly causing severe burns.
After hot glue reaches working temperature, direct glue gun nozzle toward target
area, squeeze trigger to apply melted glue.
Apply hot melt glue by continuous pressure on trigger. Glue is fed by simply
pulling the trigger. Amount of the glue is determined by how far the trigger is
pulled.
OPERATING INSTRUCTIONS
STEP 2B
CORDLESS
USE
7