Cub Cadet CC 3075 Manual Del Operador página 10

Operation (continued)
EZ-Link™ Coupler
Knob
Fig. 5-4
EZ-Link™ Coupler
Upper Shaft Housing
Fig. 5-5
90˚ Edging Hole
(Trimmer Only)
Fig. 5-6
Operating the EZ-Link™ System
The EZ-Link™ system enables the use of these optional
Add-Ons.
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBGC
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBLE
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . TBAH
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . . TBSS
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBTB
Pole Saw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBPS
10
Release Button
Guide Recess
Release Button
Primary Hole
Lower Shaft Housing
180˚ Edging Hole
(Trimmer Only)
Knob
Read and understand the operator's manual for
each add-on prior to operation.
Removing the Cutting Attachment or Add-Ons
1. Turn the knob counterclockwise to loosen (Fig. 5-4).
2. Press and hold the release button (Fig. 5-4).
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link™ coupler (Fig. 5-5).
Installing the Cutting Attachment or Add-Ons
To avoid serious personal injury and damage to the
unit, shut unit off before removing or installing add-
ons.
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a work
bench.
1. Turn knob counterclockwise to loosen.
2. While firmly holding the add-on, push it straight into
the EZ-Link™ coupler (Fig. 5-5).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 5-4).
3. Turn the knob clockwise to tighten (Fig. 5-6).
Lock the release button in the primary hole and
securely tighten the knob before operating this unit.
The cutting attachment and add-ons with the EZ-
Link™ system are to be used in the primary hole
unless stated otherwise in the specific add-ons
operator's manual. Using the wrong hole could lead
to personal injury, or damage to the unit.
For edging (when using the line head cutting attachment
with EZ-Link™ models), lock the release button of the
cutting attachment into the 90° edging hole or the 180°
edging hole (Fig. 5-6).