Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10
INSTALLATION
How to Install the Unit
1
Measure the space for installation to assure
a good fit. The air conditioner must be
installed firmly into place to prevent vibration
and noise.
2
Avoid exposure to direct sunlight.
3
Remove all obstacles from the rear of the unit.
There must be at least 50 cm (20 in.) of
cleared space around the rear of the unit.
Obstacles restricting the airflow may reduce
the cooling efficiency of the unit.
4
The unit should be installed with a slight tilt
towards the outside to allow condensed water
to drain. (About 10~15 mm or 1/4 bubble with
Level)
Foam
Awning
Cooled air
CAUTION
● The external grille must be exposed outside
for air discharge.
Preparation of the Cabinet
1
2
Fence
Heat
radiation
10~15 mm
Over 50 cm
1/4 Bubble
Level
3
Remove 4 screws which fasten the cabinet
at both sides and at the back. (Keep the
screws for later use.)
Slide the unit from the cabinet by gripping
the base pan handle and pulling forward
while bracing the cabinet.
CAUTION
● The unit is heavy. To prevent injury, use
proper lifting techniques when pulling unit
forward from cabinet. Obtain assistance
from another person if possible.
Before installing the unit back into the
cabinet , remove the white styrofoam
shipping block from the compressor
(Applicable for some models).
White styrofoam block
Shipping screws
Capítulos
Tabla de contenido
Solución de problemas
