Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING
!
• Study, understand, and follow all instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Center load on saddle.
• Use as a matched pair to support one side of a
forklift only. Use only ONE (1) PAIR per forklift.
• Forklift jack stands are not to be used to
simultaneously support both sides or one end of
a forklift.
• No alteration shall be made to this device.
• Failure to heed these markings may result in
personal injury and/or property damage.
PREPARATION
Before Use
1. Read this manual completely and familiarize
yourself thoroughly with the product and the hazards
associated with its improper use before using this
product.
2. Verify that the product and the application are
compatible, if in doubt call
(888) 332-6419.
3. Inspect stands before each use. Do not use if there are
bent, broken or cracked components noted (including
labels). Ensure that all parts move freely.
4. Roll pin is pre-installed into the bottom hole of the
extension tube to prevent inadvertent loss of the
extension tube.
5. Always refer to the forklift owners or service manual
for location of proper lift and support points.
Omega Customer Service
OPERATION
!
Use only on areas of the forklift as specified
by the forklift manufacturer. Use ONLY on forklift
whose support points are compatible with the saddle of
the jack stand. Incompatibility may result in structural
damage to the forklift and/or jack stand. Structural
damage to either may result in sudden and unexpected
loss of load height!
!
WARNING: Only attachments and/or adapters
supplied by the manufacturer shall be used.
1. Adjust saddle height by pulling up the extension
tube, then insert the tube support bar through the
hole on extension tube.
2. Ensure that support bar is secured and nested
across two corresponding radii (see Fig. 1) before
loading. Insert support bar into the extension tube
far enough to create equal distance of bar extending
from the extension tube on both sides.
3. Carefully position forklift jack stands so that load is
centered on stand's saddle.
4. Slowly lower the forklift onto the stands.
5. Check to ensure forklift is secured before working
on, around or under.
To lower load
!
WARNING: Clear all tools and personnel
before lowering load.
1. With suitable forklift jack, raise forklift clear of stands.
2. Carefully release support bar and allow extension
tube to glide down to lowest position.
3. Carefully remove stands, then carefully lower forklift
with forklift jack.
MAINTENANCE
Periodically inspect each stand. Ensure all parts move
freely. Do not apply oil or lubricant to any portion of
this product. Keep support bar in bar holder on base
section. If rust appears, sand affected area and cover
with suitable utility paint.
Storage
Store stands in upright position and in a clean, dry area.
3
Tabla de contenido
