Before You Begin - Rimage Producer 7100 Guia De Instalacion Y Configuración

Rimage Producer 7100

Before you begin:

This document includes instructions for setting up the Producer 7100 or the
Producer 8100. These products are part of the Rimage Producer III family of
products.
The term 'Producer III' is used throughout this document to refer to the
Producer 7100 or the Producer 8100.
1
Prepare the Producer III.

Important! Keep all packaging materials.
a. On the Producer III, open the
front door.
b. Cut the plastic tie wrap from the
lift arm.

Caution! Do not cut the
belt or cable!
c. If you have a Producer 8100,
remove the tape from the disc
feed tray.
d. Remove the shipping foam
inserted above the carousel.
e. Close the front door.
110870_A
and Producer 8100
™
2
Set up your printer (Everest).

Important! Keep all packaging materials.
a. Unpack the Everest printer. Refer to the Everest Unpacking
and Setup Instructions included with your Everest printer.
b. Place the printer on the
Rimage Producer III so that the
plastic feet slide into the slots
on the printer plate.
OR
2
Set up your printer (Prism).

Important! Keep all packaging materials.
a. Open the Prism printer
packing box.
b. Remove the Prism printer
from the packing box.
Tie Wrap
c. Remove the packing foam
from the ends of the Prism
printer.
d. Remove the plastic bag from
the Prism printer.
e. Remove the top cover of the
Prism printer.
f. Remove the foam inserts.
Foam
g. Replace the top cover.
h. Place the printer on the
Rimage Producer III so that
the plastic feet slide into the
slots on the printer plate.
Setup and Installation Guide
™
Printer Plate
Slots
Top Cover
Foam Inserts
Printer
Packing Foam
Printer Plate
Slots
3
Connect the printer cables (Everest).
a. Connect the printer cable
c. Connect the USB cable
from the Producer III to the
printer as indicated by the
D-shaped label.
b. Connect the
power cord from
the Producer III to
the printer.
OR
3
Connect the printer cables (Prism).

Note: The serial cable port is not used.
a. Connect the
USB cable from
the Producer III
to the printer.
b. Connect the
printer cable
from the
Producer III to
the printer.
from the Producer III to
the printer.
c. Connect the
power cord from
the Producer III
to the printer.
d. Press the Prism
printer power
switch.
1