Tabla de contenido
Idiomas disponibles
Idiomas disponibles
button to tap menu.
•
This function does not work when the
fixture is under DMX mode or fail on position res-
toration.
3.
When choose "Reset", press "SETUP' button to
enter to factory resetting mode. Press "SETUP" button
again, LCD shows "Factory Reset". Press "MODE" but-
ton back to the menu.
4.
When choose "Power", press "SETUP" button en-
ter to check the information of power supply. "Main"
means the voltage of main board; "LED" means the volt-
age of LED driver.
5.
When choose "Error", press "SETUP" button en-
ter to self-inspection. LCD shows "000000" means ap-
proved. If not, press "SETUP" button to check the mis-
take.
6.
When choose "Lamp", press "SETUP" button to
show the LEDs information
7.
When choose "Use", press "SETUP" button to
show the usage time of fixture. Press "SETUP" button
to choose "Clear Y/N". If not, press "MODE" back to the
menu
8.
When choose "Sensor", press "SETUP" button to
enter the menu:
•
P-Hall:
It is about the pan sensor
state. Press "SETUP" button to check it. LCD
shows "Hall OK" means the pan sensor runs
well. If LCD shows "LCD not good" means some-
thing wrong with the sensor.
•
T-Hall: It is about the tilt sensor state.
Press "SETUP" button to check it. LCD shows
"Hall OK" means the pan sensor runs well. If
LCD shows "LCD not good" means something
wrong with the sensor.
•
P-Rast: It is about pan coding state
and setting. Press "SETUP" button to enter to
the menu: p-sets, p-state
When choose "p-sets", could
1.
open or close the pan coding through
"UP" and "DOWN" button. When you
close the pan coding, pan could not re-
store the position.
When choose "p-state", press
2.
"SETUP" button to check the pan cod-
ing state. "Current" is the adjust times.
"History" is the total amount of the ad-
just times. Press "SETUP" button, LCD
P. 12
QUATROBEAM MOVE
ENGLISH VERSION
Tabla de contenido
