Defiant DFI-0452-WH Guía De Uso Y Cuidado página 10

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Operation (continued)
Determining the motion
3
sensor detection zone
NOTE: The motion sensor (C) is adjustable. It has a
sensing angle of 180° and a range of approximately 50 ft.
depending on the surrounding temperature.
NOTE: When you turn ON the light (B), it will begin a 3
minute test mode. The photocell and motion detection will
be deactivated. After the first minute, motion detection will
be activated, but the photocell will remain deactivated.
After 3 minutes, the unit will set to AUTO mode, and both
photocells and motion detection will be enabled.
NOTE: The motion sensor (C) will need to completely
warm up (60 seconds) before beginning the setup process.
□ Push the switch button to the AUTO position. For the
first minute, the light is in test mode. The lamp heads
will stay on for 1 minute.
□ After the initial minute in test mode, motion detection
will be activated. You will have 2 minutes to perform a
"walk test", which will help in identifying the coverage
area of the motion sensor (C).
□ Walk in an arc across the front of the motion sensor
(C), and watch the indicator light (1). If the motion
sensor (C) detects movement, the indicator light (1)
will flash green, and the lamp heads will stay on for 30
seconds after the detection (regardless of any further
motion.)
□ After 30 seconds, the indicator light will turn OFF and
reset for another detection. This cycle can be repeated
up to 4 times, and it is recommended that the motion
sensor (C) be adjusted for optimal detection during
these cycles.
□ After 4 motion test cycles, or 2 minutes after the initial
test mode, the light will automatically switch to AUTO
mode.
4
Adjusting the light timer
NOTE: The TIME dial controls the amount of time the light
(B) will stay on full brightness after motion has been
detected. The timer is adjustable from 1 minute to 5 minutes.
□ To increase the time, turn the TIME dial towards the
5 minute position.
□ To decrease the time, turn the TIME dial towards the
1 minute position.
10
1
C

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido