Bernzomatic JT850 Manual De Instrucciones página 3

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

LIGHTING AND OPERATION
CAUTION
Tipping the gas cylinder more than 60 degrees from its upright position may cause torch to flare. It is recommended to
start working with a disposable hand torch cylinder at room temperature and to keep torch upright as much as possible.
1. Turn valve control knob (1) ¼ to ½ turn counterclockwise to open the valve.
2. Depress the ignition button (2) to light. If the torch does not light right away, depress the ignition button (2) again.
3. Once lit, turn control knob (1) fully counterclockwise. Do not force.
TO USE
1. Inspect torch before each use. Do not use if torch malfunctions or is damaged.
2. Hold torch by the handle (3) at the curved part of the tube.
3. Sweep burner tip (4) back and forth over target area, keeping the flame about 2" above the ground.
4. SHUT OFF TORCH BEFORE SETTING DOWN
TO SHUT OFF
1. Turn the valve control knob (1) fully clockwise to OFF position.
2. Wait for flame to extinguish.
3. Set torch down on non-combustible surface and let cool. Tip (4) will remain hot for several minutes after torch is shut off.
STORAGE
REMOVE CYLINDER FROM TORCH WHEN NOT IN USE
1. Make sure valve control knob (1) is closed by turning fully clockwise until it stops." Do not force.
2. When torch is cool, disconnect cylinder and store torch and cylinder separately and out of reach of children.
Observe cautions on cylinder label.
3. Do not expose cylinders to temperatures in excess of 120ºF.
4. Store cylinders in well ventilated areas.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
08/19/16
Tabla de contenido
loading

Tabla de contenido