Replacing Filters; Cleaning Care; Cleaning The Filters - Winix Zero S Manual Del Usuario

REPLACING FILTERS

item: 116130

CLEANING CARE

Cleaning the Filters:

Use a vacuum cleaner or soft brush to clean the Pre-Filter
• If it is excessively soiled, rinse in room temperature water.
• Do not use detergent or soap.
• Allow the filter to dry for 24 hours or more before using.
• Intervals between filter cleaning may vary depending on
the air quality in the environment.
• Do not use hot water over 40°C.
Particle Sensors Care
1.
Use a damp cotton swab to wipe the
lens and intake area of the Particle
Sensor.
• To clean the sensor area, use
only water. Do not use volatile
substances such as alcohol or
acetone.
2.
Wipe away any remaining moisture
with a dry cotton swab.
N O T I C E
• Do not use benzene, alcohol, or other volatile fluids,
which may cause damage or discoloration.
8 Zero S
Cleaning the Exterior & Interior:
Wipe with a soft damp cloth using room temperature water.
• Afterwards, wipe it down with a clean, dry cloth.
Open the front panel and clean the interior with a vacuum
cleaner.
• For optimal performance, clean every 1 - 2 months.
N O T I C E
Lens • When cleaning the unit, always unplug the power cord
first and then wait until the unit has cooled down.
• Never disassemble, repair, or modify this unit yourself.
Cotton swab • Do not use flammable sprays or liquid detergents.
• Do not allow children to clean or maintain the unit.
• Before cleaning or maintaining, ensure unit is unplugged.
After replacing a filter, press
the Filter Reset Button for at
least 5 seconds.
English