Troubleshooting - DieHard DH156 Manual Del Propietário

8. IF THE CONVERTER'S FUSE BLOWS
Your power converter is fitted with a fuse, which should not have to be replaced
under normal operating conditions. A blown fuse is usually caused by reverse
polarity or a short circuit within the device or equipment being operated.
If the fuse does blow:
Disconnect the device or equipment immediately. 1.
Find the source of the problem and repair it.
2.
Install a new 15 amp fuse. The fuse can be found on the end of the plug
3.
on the converter.
Do not overtighten the fuse cap; finger-tight is sufficient.
4.
IMPORTANT: Do not install a fuse higher than 15 amp, as this may damage
the converter. Make sure to correct the cause of the blown fuse before using
the converter again.

9. TROUBLESHOOTING

PROBLEM
LEDs do not light, or
converter does not
function.
POSSIBLE CAUSE
Poor contact at terminals.
Blown fuse.
Converter has shut down.
• 10 •
REASON/SOLUTION
Unplug and reinsert the
12 volt plug.
Replace the fuse.
See LED Indicator and
Shutdown Protection
section.