Ventura BIKE-PACK System Manual Del Usuario

Thank you for purchasing our VENTURA BIKE-PACK SYSTEM.
Before use please read all instructions and our Limited Warranty carefully.
To Fit : Honda VTR 1000 SP-1 Y (2000)
H100/B L-Brackets.
PF19/B Pack-Rack. For use with 'Aerodynamic' system packs.
SR19/B Sport-Rack
GH13/19/B Grab-Handle
A range of various style packs for the 'Aerodynamic' systems,
along with storm covers and optional shoulder straps (where
applicable) are available.
Check with your local dealer, distributor or contact us direct for
the latest models.
FITTING KIT CONTENTS
LD001/B locking device (fitted to L-Brackets)
1 LK001/S Key
1 Part # 387 L (black zp)
1 Part # 387 R (black zp)
2 70mm long pieces of 18mm foam tape
2 M6 x 12.5 x 1.2 flat washers (black zp)
2 M8 x 16 Allenhead bolts (black zp)
2 M8 x 17.0 x 1.4 flat washers (black zp)
2 M8 x 22.0 x 3.0 flat washers (black zp)
2 M6 x 40 Allenhead bolts (black zp)
2 M8 Spring washers (black zp)
FITTING INSTRUCTIONS
1 Remove seats and rear body.
2 Remove and discard rear mudguard to frame mounting
bolts, retain nuts.
3 Take foam tape, remove backing strip and fit tape to
underside of the flat bracket on part # 387 L/R that rest on
top of the rear subframe tubes.
Fit Part # 387 L/R to fit over the rear subframe with the
bracket with the hole to line up with the mudguard to frame
mounting points on the inside of the frame and the
threaded bush to the outside and in the middle of the
luggage tie-down hooks.
4 Secure Part # 387 L/R with the M6 x 40 Allenhead bolts
and M6 washers supplied and the original nuts. Leave
loose.
H100B.es : Issue 1 : May 2001
Manufactured by:
Diagram 1
Legend to
Diagram 1:
5 Remove all pillion foot rest casting to frame mounting
bolts. Replace front bolts with a M8 x 22.0 x 3.0 flat
washer inserted between the foot peg casting and the
frame. Leave loose.
6 The front L-Bracket mount is secured between the rear
casting mount and the frame using the original bolts.
Leave loose.
7 The rear L-Bracket mount is secured to the threaded bush
on Part #387 using the M8 x 16 Allenhead bolts and M8
Spring washers provided. Leave loose.
NOTE: Additional washers have been supplied to adjust width if
necessary.
8 Fit Pack-Rack or Sport-rack into L-Brackets, ensure the
rack is level and tighten all mounting bolts.
9 Remove rack.
10 Refit rear body and seats.
11 Refit rack and tighten L-Bracket locking devices by
following the procedure in the General Instructions For
Use.
17 Perclo Place, P.O. Box 10-393, Te Rapa, Hamilton, New Zealand
Telephone +64 (7) 849 4392, Facsimile +64(7) 849 4114
E-mail: [email protected] Internet: www.ventura-bike.com
1
Part # 387
2
M6 x 40 Allenhead bolt
3
Original nut
Page 1 of 5